Mitre Angle Calculator

Choose the number of corners of a frame to count the mitre cuts, two for each corner. The saw settings for flat trim, crown moulding and a regular polygon are worked out in the example and table.

Estimates for planning, not professional advice. Read the full notice.

Corners

Example: a square frame and an eight-sided one

8 mitre cuts

  • Flat trim, each piece cut at 45 degrees
  • Crown on the flat, mitre angle 31.62 degrees
  • Crown on the flat, bevel angle 33.86 degrees
  • Regular polygon, corner 135 degrees
  • Regular polygon, each piece cut at 22.5 degrees

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

Saw settings

Type your angles in degrees. A box left empty is skipped.

The angle between the two walls, measured inside the corner.

The angle of the crown's back against the wall, from the moulding's package.

A whole number of sides, from three.

  • Mitre cuts to make, mitre cuts 8

Share this project

This link carries:

    The project is inside the link, after the # sign. Browsers do not send that part to the site.

    Questions

    How do I find the mitre angle for a corner?

    Measure the angle between the two walls, take it from a straight line and halve what is left. A square corner gives a flat trim mitre of half a right angle. The table lists settings for common corners.

    What is the spring angle of crown moulding?

    It is the angle between the back of the crown and the wall. It is printed on the packaging, and the table uses two example spring angles; yours is the one on your moulding.

    Worked example: a square frame and an eight-sided one

    Show the steps
    1. What is left of a straight line at the corner 180 degrees − 90 degrees = 90 degrees
    2. Each flat piece is cut at half of that 90 degrees ÷ 2 = 45 degrees
    3. Cuts: two for each corner 4 corners × 2 cuts = 8 mitre cuts
    4. A regular polygon's corner: the sides less two, over the sides, times a straight line 6 ÷ 8 sides × 180 degrees = 135 degrees

    Assumptions

    The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.

    AssumptionValueDetails and changes

    Saw settings by corner angle

    Flat trim mitre and crown-on-the-flat mitre and bevel for corners from eighty to one hundred and fifty degrees, at two spring angles

    Flat trim mitre and crown-on-the-flat mitre and bevel for corners from eighty to one hundred and fifty degrees, at two spring angles
    CornerFlat trimCrown 38: mitreCrown 38: bevelCrown 45: mitreCrown 45: bevel
    80° 50 degrees36.27 degrees37.13 degrees40.12 degrees32.8 degrees
    90° 45 degrees31.62 degrees33.86 degrees35.26 degrees30 degrees
    100° 40 degrees27.32 degrees30.43 degrees30.68 degrees27.03 degrees
    110° 35 degrees23.32 degrees26.87 degrees26.34 degrees23.93 degrees
    120° 30 degrees19.57 degrees23.2 degrees22.21 degrees20.7 degrees
    130° 25 degrees16.02 degrees19.45 degrees18.25 degrees17.39 degrees
    140° 20 degrees12.63 degrees15.64 degrees14.43 degrees14 degrees
    150° 15 degrees9.37 degrees11.77 degrees10.73 degrees10.55 degrees

    The two spring angles are examples; yours is on the moulding's packaging. Crown settings are for crown laid flat on the saw table.