Roof Pitch Calculator

Enter a rise and a run, or an angle or a percentage, and get the roof pitch in degrees and as a percentage, with the multiplier and the math shown.

Estimates for planning, not professional advice. Read the full notice.

Roof rise and run

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 900 millimetres, 2 feet 11 and 7 sixteenths inches

Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm

reads as 3.6 metres, 11 feet 9 and 3 quarters inches

Example: a roof pitch

14.04 degrees

  • Slope as a percentage 25 per cent
  • Multiplier 1.031

Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.

Questions

How do I measure my roof pitch?

Hold a level against a rafter, measure the gap between the level and the rafter at the far end of the level, and enter that gap as the rise and the length of the level as the run. The calculator turns the two into the pitch.

How do I enter a pitch said as a rise in twelve?

Enter the rise as the first number and twelve as the run, in the same unit, such as 4 and 12. The calculator then shows the angle, the percentage and the multiplier of that pitch.

How do I change a percentage into degrees?

Enter the percentage. The calculator works out the angle whose tangent is the percentage divided by one hundred and shows the pitch in both forms, with the working beside it.

What is the multiplier for?

The multiplier is one divided by the cosine of the angle. Multiplied by the flat area under a plane, it gives the area of the sloped surface.

Does the calculator say whether my pitch suits a roof covering?

No. It only converts a rise and a run into an angle, a percentage and a multiplier. The minimum pitch for a covering is set by its maker, so check the maker's own figure.

What is the multiplier when the rise equals the run?

The angle is half a right angle and the multiplier is the square root of two. The table shows it worked out, not copied from another chart.

Worked example: a roof pitch

Show the steps
  1. Percentage: the rise divided by the run, times one hundred 900 mm (2 ft 11 7/16 in) ÷ 3.6 m (11 ft 9 3/4 in) × 100 = 25 per cent
  2. Angle: the angle whose tangent is the percentage divided by one hundred 25 per cent ÷ 100 = 14.04 degrees
  3. Multiplier: one divided by the cosine of the angle 14.04 degrees = 1.031
  4. Rise for each metre of run: the percentage divided by one hundred, times one metre 25 per cent ÷ 100 × 1 m (3 ft 3 3/8 in) = 250 mm (9 13/16 in)

Find your pitch

  1. Hold a level against the underside of a rafter, with the bubble centred.
  2. Measure straight up or down from the level to the rafter at the far end of the level.
  3. Enter that gap as the rise and the length of the level as the run.

From an angle or a percentage

The pitch in degrees, as a percentage and as a multiplier, starting from an angle or from a percentage

The pitch in degrees, as a percentage and as a multiplier, starting from an angle or from a percentage
You haveDegreesPercentageMultiplier
15 degrees 15 degrees26.79 per cent1.035
30 degrees 30 degrees57.74 per cent1.155
25 per cent 14.04 degrees25 per cent1.031
100 per cent 45 degrees100 per cent1.414

The multiplier is one divided by the cosine of the angle, so it is the same for every roof at that pitch.