Carpet Calculator
HoneyDoMath.com
Enter a room's length and width and your roll width to get the drops, seams and linear metres of carpet, with the drops run both ways and the shorter kept, rounded up once to whole metres. A drawn shape is counted as its bounding rectangle.
Estimates for planning, not professional advice. Read the full notice.
The drawing did not open. Length and width are still here.
Room: shape and size
Skip the drawingDrag a round corner to move it. The small hollow diamond on a side is its curve handle: drag it across the side to curve the side (it is not a corner). To add a corner (a new point), tap the side itself, then choose Add a point here. Tapping a corner or a side opens its actions. Drag empty space to move the view; pinch, or Ctrl and the mouse wheel, to zoom. The keys are listed under Keys.
Keys
- Tab
- next corner; each says how far it is from corner 1
- Arrow keys on a corner
- move it one square; ten with Shift; 1 mm with Alt
- Delete or Backspace
- remove the corner; its two sides join in one straight side
- + on a corner
- add a corner halfway along the next side
- Arrow keys on the drawing
- move the view; farther with Shift
- + and - on the drawing
- zoom in and out
- 0 on the drawing
- show the whole shape
- Ctrl+Z (Cmd+Z on a Mac)
- undo, except inside a typed field (it keeps its own)
- Ctrl+Shift+Z or Ctrl+Y
- redo
- Escape while dragging
- put it back where it was
- Enter on a corner or side
- go to its actions
- Escape in the actions
- close them and go back to the drawing
The drawing did not load. Check your connection and try again.
- Area
- 23.4 m² (251.88 ft²)
- Perimeter
- 19.4 m (63 ft 7 3/4 in)
- Cut-out edges
No area until the shape is fixed.
Estimate for planning, from what you entered and the product data shown. Check product labels and your supplier before you buy.
Shape: Rectangle Change
Sides
Corners
Cut-outs
Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm
Example: a living room
9 m of carpet
- Carpet bought 36 m² (387.5 ft²)
- Drops 2 drops
- Seams 1 seam
- The other way: linear metres 11 m (36 ft 1 1/16 in)
Result
Enter a size to see your total.
Each product is rounded up once for the whole project, so the total can be less than the items bought alone added together. A line counted from a cut layout (sheets, boards or tiles laid out piece by piece) is counted for each item and added.
- Carpet, by the linear metre, m of carpet 9
Questions
Why not multiply the area by a waste factor?
Carpet comes in a fixed roll width, and the room is covered by whole drops with seams between them. A room a little wider than the roll needs a whole extra drop for the strip left over, so the roll length decides the buy, not the area.
Which roll width do I use?
Enter the width of the roll your supplier cuts from. The calculator makes no claim about which widths are sold.
What if I draw an L-shaped room?
A drawn shape is counted as its bounding rectangle, the smallest rectangle that holds it, so the count can be more than the shape needs. Type each part as its own room for a closer count.
Worked example: a living room
Show the steps
- Full drops across, and the fill strip left 5.2 m (17 ft 3/4 in) ÷ 4 m (13 ft 1 1/2 in) = 1 full drop
- Add the fill strip as one more drop 1 drop + 1 fill strip = 2 drops
- Linear metres: drops times the length of a drop 2 drops × 4.5 m (14 ft 9 3/16 in) = 9 m (29 ft 6 5/16 in)
- Round up once, to your supplier's whole metres 9 m (29 ft 6 5/16 in) = 9 m of carpet
Assumptions
The figures behind the example. Sourced figures link to their source below; a default is a starting value to check against your label or supplier.
| Assumption | Value | Details and changes |
|---|---|---|
| Roll width | No default | |
| Default Your roll's width, from your supplier; the figure shown is an example to start from. Check your label or supplier. | ||
| Trim on each drop | 0 mm (0 in, converted) | |
| Default Extra length on every drop, your own allowance. Check your label or supplier. | ||
Metres, centimetres or millimetres, like 3.8 m, 10 cm or 250 mm
The drops run both ways
Drops, fill strip, linear metres and seams for the example room with the drops run along each side
| Layout | Drops | Fill strip width | Linear metres | Seams |
|---|---|---|---|---|
| Drops along the longer side | 2 | 500 mm (1 ft 7 11/16 in) | 11 m (36 ft 1 1/16 in) | 1 |
| Drops along the shorter side | 2 | 1.2 m (3 ft 11 1/4 in) | 9 m (29 ft 6 5/16 in) | 1 |
The calculator keeps the way that needs fewer linear metres, and the fewer seams on a tie. Pile runs the same way on every drop and no pattern is matched.